• Generally, be stored in a vertical tank with the heating system.

• Available in 200 liters and bulk supply in tankers.

• Generally, be stored in a vertical tank with the heating system.

• Available in 200 liters and bulk supply in tankers.

• Generally, be stored in a vertical tank with the heating system.

• Available in 200 liters and bulk supply in tankers.

• Generally, be stored in a vertical tank with the heating system.

• Available in 200 liters and bulk supply in tankers.

The surface must be thoroughly cleaned, free of dust, dirt, debris, grease and oil. The surface must be dry. If applied over concrete, it must be thoroughly cured. It can be applied by squeegee, spray, brush or rollers.

• Tools : Clean with kerosene.
• Hands : Use a hand cleaner or kerosene followed by soap and water.

Over concrete : 0.5 to 0.7 Ltr/M2

Base complies with ASTM D449, Type II

20-litre pails and 200-litre drums.

Flammable; contains petroleum distillate. Keep away from open fire, sparks or other ignition sources. Wear protective clothing, gloves and goggles.

• Fire Flammable when wet, flash point 40 °C.
• Skin Avoid repeated or prolonged contact; if contact occurs, remove with hand cleaner that removes oil or grease; then clean with soap and water.
• Eyes Contact could cause irritation. If contact occurs, flush with clean water.
• Inhalation Can cause dizziness. Remove to fresh air and if breathing difficulty persists administer oxygen.

The surface must be thoroughly cleaned, and all dust, dirt, loose coating, oil and grease removed; concrete must be thoroughly cured, and dried before priming. Before application of subsequent layers, Primer D41 should be allowed to dry.
It can be applied with a roofing brush, roller, squeegee, or airless spray equipment at the recommended coverage rates.

• Tools : Clean with kerosene.
• Hands : Use a hand cleaner or kerosene followed by soap and water.

• Metal : 0.15-0.25 L/M2
• Concrete smooth asphalt : 0.20-0.30 L/M2
• Mineral granule surfaces : 0.30-0.50 L/M2
• Coarse aggregate : 0.80-1.00 L/M2

Complies with ASTM D 41.

18-litre pails and 200-litre drums.

Contains petroleum distillate; flammable; keep away from open fire, sparks or other ignition sources. Wear protective clothing, gloves, and goggles.

• Fire Flammable when wet, flash point 40 °C.
• Skin Avoid repeated or prolonged contact; if contact occurs, remove with hand cleaner that removes oil or grease; then clean with soap and water.
• Eyes Contact could cause irritation. If contact occurs, flush with clean water.
• Inhalation Can cause dizziness. Remove to fresh air and if breathing difficulty persists administer oxygen.

The surface should be clean dry & free from dirt, dust, oil and grease.

Hot applied using a trowel, stiff brush or a mop.

Oxidized asphalt grade 115/15 is packed in 200 kgs drum and in polyamide bags of 25kg.

The rate of application will depend on engineers. Requirement and may vary from project to project. As a general rule two coats are applied consuming 1 kg per so. M. Per coat.

• Care should be taken while heating & handling during application. Strictly recommended to use protective clothing. Gloves, masks, goggles, etc.
• In the event of contact with hot oxidized asphalt on the skin, immediately apply ice or cold water at first instance followed by seeking medical advice.
• Oxidized asphalt is a non-flammable & non-hazardous item.